Why am I unable to add action nodes to the campaign sequence?

While creating a campaign in the Flowkon Campaign sequence, you may notice that you are unable to add a new action or sequence at a certain point in the workflow. This is expected behavior in some cases and is usually caused by the End of Sequence node being automatically added to your campaign.

Why Does This Happen?

Flowkon automatically appends an End of Sequence node at the end of your campaign workflow when:

• You save the campaign while it is still being created.
• You navigate away from the Campaign Builder (for example, by switching to another tab or page) and return later to continue editing.

This ensures that the campaign always has a valid endpoint and that your progress is saved.

Why Can't I Add More Actions?

The End of Sequence node marks the completion of your campaign workflow.

Once this node is present, no additional action nodes can be added after it because the campaign is considered complete.

If you want to continue building your campaign, you must first remove this node.

How to Continue Building Your Campaign

If you accidentally saved the campaign or left the builder before finishing, don't worry. You can continue editing your workflow by following these steps:

1. Open the campaign in the Campaign Builder.
2. Locate the End of Sequence node at the end of the workflow. Delete the End of Sequence node.

3. Click the + (Add Action) button where you want to continue building.

4. Add any action node you require, such as: 
   • Visit Profile
   • Like a Post
   • Follow Profile

5. Continue building your workflow as needed.
6. Once you have finished adding all actions, save the campaign. Flowkon will automatically add a new End of Sequence node at the end of the completed workflow.

Best Practices

• Complete your workflow before saving whenever possible.
• If you need to pause campaign creation, you can safely save your progress and continue later.
• When returning to edit an unfinished campaign, check whether an End of Sequence node has been added automatically.
• Simply remove the End of Sequence node to continue adding actions.

Frequently Asked Question

Why can't I add another action after my last step?

This usually means the End of Sequence node has been automatically added to your workflow. Delete the End of Sequence node, and you will be able to continue adding any action nodes to your campaign. After saving, Flowkon will automatically place a new End of Sequence node at the end of the completed workflow.